Very good quality automotive waterproof breathable membrane
| PHYSICAL PROPERTIES | REFERED TEST STANDARD | UNIT | TYPICAL DATA |
| Membrane Color | / | / | Black |
| Membrane Construction | / | / | PTFE / PET Fabric |
| Membrane Surface Property | / | / | Hydrophobic |
| Thickness | ISO 534 | mm | 0.12±0.05 |
| Interlayer Bonding Strength (90 degree peel) | Internal Method | N/inch | >2 |
| Min Air Flow Rate | ASTM D737 | cm³/min/cm²@7kpa | >1300 |
| Typical Air Flow Rate | ASTM D737 | cm³/min/cm²@7kpa | 2000 |
| Water Entry Pressure | ASTM D751 | kPa for 30 sec | >50 |
| IP Rating | IEC 60529 | / | IP68 |
| Water Vapor Transmission Rate | GB/T 12704.2 (35C/90%RH, Cycle) | g/m²/24h | >5000 |
| Oleophobic Grade | AATCC 118 | Grade | NA |
| Operation Temperature | IEC 60068-2-14 | ℃ | -40℃～125℃ |
| ROHS | IEC 62321 | / | Meet ROHS Requirements |
|
REACH SVHC |
REACH Regulation 1907/2006/EC |
/ | Meet REACH Requirements |
This series of membranes could be used in Automotive Lamps, Automotive Sensitive Electronics, Outdoor Lighting, Outdoor Electronic Devices, Household Electrical and Electronics etc.
The membrane can balance inside/outside pressure differentials of sealed enclosures while blocking contaminants, which could increase components’ reliability and extend their service life.
Shelf life is 5 years from the date of receipt for this product as long as this product is stored in its original packaging in an environment below 80° F (27° C) and 60% RH.
All data above are typical data for the membrane raw material, for reference only, and should not be used as special data for outgoing quality control.
All technical information and advice given here is based on MJ’s previous experiences and test results. MJ gives this information to the best of its knowledge, but assumes no legal responsibility. Customers are asked to check the suitability and usability in the specific application, since the performance of the product can only be judged when all necessary operating data are available.